X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: Tuicemen on March 29, 2005, 10:58:58 AM

Title: AM &SR bugs
Post by: Tuicemen on March 29, 2005, 10:58:58 AM

Ok this may only be a win 98 issue but:
Activity monitor stopped showing sent
commands macros,timmers or anything
triggered from a motion, palm pad,or remote.
The CM15A is working &sending the correct
info the AM just isn't showing clearing it
and restarting AHP have no effect.
The Status Report will not show flag status
reliably I use AHPs dusk/dawn feature yet
flags 15&16 never show set. If it can't
report those correct how can we depend on it
to correctly show our flags?
These 2 bugs seem to have been introduced
with the new ver 3.183
X10 Pro I've tried to get the AM working
short a reboot I have the Diagnostic unit.
I'll wait till tonight before I reboot in
case you'd like more info.

Title: Re: AM &SR bugs
Post by: Tuicemen on March 30, 2005, 12:47:52 PM

just added a macro into the mix downloaded
it an presto the AM is working again. Last
time it just started to work on its own. It
seems it is getting harded to get this to
start working again.

Title: Re: AM &SR bugs
Post by: WinS on March 30, 2005, 04:42:54 PM

Tuicemen, I received the diag unit and
updated to 3.180 on the same day (weeks ago)
and noticed that flags 1,15,&16 no longer
showed up on the status report.  But,
dusk/dawn timers work fine.

Title: Re: AM &SR bugs
Post by: Tuicemen on March 31, 2005, 01:21:55 PM

Win S:  My dusk/dawn timers work fine as
well I think from reading the posts here
there is a Flag problem not just the AM.