X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: bob chapman on April 08, 2005, 05:09:08 PM

Title: Error message
Post by: bob chapman on April 08, 2005, 05:09:08 PM

I don't know if I have a hardware or a
software problem.  But here it is.

I have AHP open, the Interface connected,
and all the timers and commands downloaded
to the Interface.  I tell manually AHP to
switch on a light that is in the room where
I'm working with the computer.  The light
switches on just fine, but an error message
comes up telling me that there has been a
communitcation problem with the interface,
and that I need to re-download the commands
and timers to the Interface.

Does anyone know what causes this? or what
I have done wrong?

Bob Chapman

Title: Re: Error message
Post by: Tuicemen on April 08, 2005, 05:56:38 PM

Are you useing 98 or M.E. I occassionally
got this with those two OS but I could never
nail down the cause. I never get this with
XP.

Title: Re: Error message
Post by: Charles Sullivan on April 08, 2005, 08:38:50 PM

I've experienced an intermittant problem with
an (otherwise flaky) CM15A which may or may
not be related to yours. I many cases I could
"cure" the problem by merely unplugging the
CM11A from the wall and plugging it back in
again.

Title: Re: Error message
Post by: bob chapman on April 09, 2005, 09:03:52 PM

I'm running XP SP2.

Title: Re: Error message
Post by: Tuicemen on April 10, 2005, 05:55:41 PM

It sounds like it is software have you tried
earlier versions of AHP? What version are
you running?