X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: james couper on April 20, 2005, 09:32:52 AM

Title: RF Transmit A1
Post by: james couper on April 20, 2005, 09:32:52 AM

I'm still not getting a RF Transmit on Unit
A1 a Chime on A1 responds but the TM571 does
not turn on. B1 Works c1 Works. These show
that the Rf was Transmitted This problem was
also with the last update.

Title: Re: RF Transmit A1
Post by: X10 Pro on April 20, 2005, 12:17:56 PM

How are you transmitting the RF command?
Using a macro, or by flipping the switch on
the TM751 on screen?

Title: Re: RF Transmit A1
Post by: martin on April 20, 2005, 02:28:53 PM

It doesn't work for me if the TM751 is set
to the same House Code as your Monitored
House Code. If set to a different house
code, it works both from the UI and as part
of a macro. I'm using two TM751 as appliance
modules in my AHP configuration.

Title: Re: RF Transmit A1
Post by: Brian H on April 20, 2005, 04:23:54 PM

The TM751 only responds to RF signals. Any
Power Line signals turning ON A1 will not
activate the TM751s appliance type relay. It
has no power line X10 receiver in it only an
RF from remote one.

Title: Re: RF Transmit A1
Post by: martin on April 20, 2005, 05:40:16 PM

Brian,

Correct but the CM15A can issue the required
RF command (i.e. A1).
CM15A can send (like a PalmPad) and receive
RF commands.