X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: peyton anness on June 18, 2005, 10:02:51 PM
-
Hi there, my first post to the forum.
I have an Ultramate ELK-9100 controlling my
water heater and as a bridge. It worked fine
with the old serial AH interface. I upgraded
to AHP with the CMA15 with no big issues,
however the interface will not trigger the
ELK-9100 in a timer, works fine manually at
the switch or if switched through the program
(and the CMA15 w/usb) The module is about 40
wiring feet away and all other mudules are
working fine with the timers.
Any Ideas ??
I have switched the control codes and am open
to suggestions,
Thanks
-
I also have an Elk module. I also used it
with my CM11A and now use it with my CM15A.
I was unable to control the Elk with my
CM15A plugged into the same outlet that I
used to have my CM11A. I found that by
locating my CM15A closer to my electrical
box my Elk started operating correctly. I
don't know if the CM15A puts out a signal as
clean as the CM11A or what, but don't give
up. The signal just needs to be strong and
clean enough to trigger the Elk.
-
I forgot to mention, in AHP I selected a 20
Amp Heavy Duty Appliance Module to represent
my Elk. Good luck.