X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: stevew on October 18, 2005, 10:24:59 PM

Title: On button runs Off macros?
Post by: stevew on October 18, 2005, 10:24:59 PM
If I assign an "on" macro to "A1 On" and
an "off" macro to "A1 Off", both fire when
I  press the A1 On button on an HR12A. What
am I  doing wrong??    Macros reside in
CM15A interface.
Title: Re: On button runs Off macros?
Post by: andy d on October 20, 2005, 01:21:31 PM
I have been using a key chain remote to
initiate  ON and OFF triggered macros.  That
setup has worked reliably for over 10
months.  I use different house codes for the
keychain remote, the macro addresses, and
the controlled devices.

My functions are H1 ON trggers a macro that
turns on porch lights for 15 minutes; H1 OFF
turns off the porch lights immediately.
Similarly H2 controls power to my garage
door opener.  The only anomaly I have seen
is that I must wait about 2 seconds after an
ON command before I issue an OFF command or
it will be ignored.

Andy D.
Title: Re: On button runs Off macros?
Post by: SteveRF on October 22, 2005, 06:47:18 PM
Are you sure both are firing or are you just
seein the flash on the room monitor ?  I have
a 3 part macro that fires all three buttons
when observed on the monitor, however, the
macro was only executing one part.
steveRF