X10 Community Forum

📸Cameras & Camera Software => Camera General Discussion => Topic started by: chasonek on January 26, 2005, 09:51:38 PM

Title: Dual Trancievers on some House Code.
Post by: chasonek on January 26, 2005, 09:51:38 PM

I was wondering IF it was possible to have
two trancievers set to the same house code?
The reason is because I do not have but 4
X10 items and one remote.
The problem is that I live in a mobile home
and the motion detectors can not get past
the metal of the mobile, nor can the remote.
I was wondering IF I could have one out in
my shed that is close to the motion
detectors and the one in the house?
Would the send the ON/OFF command to the
Cameras and cancel out each other or what?

Plus the motion detector can not get any
signal to my VCR Commander II.

Chas

Title: Re: Dual Trancievers on some House Code.
Post by: jb on February 01, 2005, 12:06:37 AM

The problem you are most likely exp. is that
the outlets your tras is plugged into is
probably on a different phase than the
outlets of your cam etc.  all devices being
used must be on the same phase or a phase
coupler must be installed.