X10 Community Forum
📸Cameras & Camera Software => Camera General Discussion => Topic started by: p straube on May 11, 2005, 12:05:47 PM
-
I have an NightWatch2 camera. the cord was
just a bit short for where it needed to be
placed so I used a telephone extension cord
with a coupler so I could get it hooked
up. Now, the picture is fine but there is
no sound. The sound works without the
cord. The cord and coupler works fine if I
use it with a telephone. When using a
coupler, does that change the order of the
wires so that like a CAT5, it has to be
wired very specifically? This is a Radio
Shack extension cord and coupler. Any
other thoughts will be appreciated.
-
Phone cords most times reverse the order
from end to end. That maybe the problem.
-
You may also want to check the original
connector, on the off chance it uses more
than the normal 4 conductors.
-
Reverse, huh? Good thought. I'll check
that out. Thanka a lot for pointing that
out.