X10 Community Forum

📸Cameras & Camera Software => Camera General Discussion => Topic started by: burt on May 31, 2005, 12:45:43 AM

Title: motion detectors timing
Post by: burt on May 31, 2005, 12:45:43 AM

How should the motion detectors timing be
set for multipul cameras?So as someone walks
around the house it will switch cameras to
follow them?I'm confused because the
commander stays on for 6 min.If I time them
too short it'l record blank parts,it
requires 8 min. timing to cover the
commander's 6 min.Any suggestions are
appreated.

Title: Re: motion detectors timing
Post by: c a smith on June 04, 2005, 01:10:53 AM

I believe the new Ninja roboctic cameras
detect and follow movement without motion
detectors

Title: Re: motion detectors timing
Post by: c a smith on June 04, 2005, 01:17:52 AM

Burt, just make sure the wind does not blow
to much where you live or the gears, the
plastic ones on Ninja may not last long, I'm
sitting here laughing, sorry, thinking about
camera chasing the wind, at least the
picture on your TV monitor would be moving,
lol