X10 Community Forum
📸Cameras & Camera Software => Camera General Discussion => Topic started by: craig on June 10, 2005, 09:18:42 AM
-
I've put a wireless camera connected to a
Ninja Pan N Scan near my front door. The
pan and scan is working great, but I
haven't hook the VCR commander (or iWitness
which I plan on getting) up to the camera
yet. My questions...
1. Is the camera always on?
2. If I want to activate the camera with a
motion sensor, how do I do that? If the
Pan N Tilt is working off of code A1, is
the camera working off of A1?
Thanks
-
I believe the camera gets it's power from
the Ninja base so yes A1 wound be the code
-
If you only have one camera, then it will
remain on until it receives an off signal
although I do believe I've seen them turn-
off by themselves.
If you use a motion sensor, some of those
can be set to send an off signal atfer the
time you set.