X10 Community Forum
📸Cameras & Camera Software => Camera General Discussion => Topic started by: jaames on September 04, 2005, 01:11:41 PM
-
I have two wireless floodcams and the VCR
Commander. If I turn one cam on at a time I
see the picture on TV, so how can I switch
cams and see one at a time without having
to turn the other two off. Also, if all
cams are turned on, will the one activated
turn on VCR?. I beleive I need to put the
switch in the cam to "manual" to use
controller to switch cams but if I use
manual and cam is off will it turn on when
activated by motion.
-
Only one camera can be sending a video
signal at a time. More than one on will
scramble the signals from all the ones on.
That is why the addressable power supplies
work in groups of 4. 1-4;5-8;9-12;13-16.
Send an ON signal to any camera of a group
and the other three cameras turn off.
-
Ok I have my two flood cams on C7 and C8.
My question is how can I switch between
them on the TV. How can I look at one cam
on the TV and hen switch cams to see the
other cam. By the way your a great help to
all of us.
-
Do you have any camera or general X10
Remotes and a Tranceiver? Like a TM751;RR501
or an AHP cm15a interface?
-
I have the protector plus SH624,
TM751,HR12A Palm Pad and two VT38A cameras.
-
im haveing the same problem. mine are on
code a 5-8. when the flood cam is activated
by motion i cannot shut it off with the
remote
-
Have you tried in the X10 Support area? They
have Quick Install and Detailed Install
Instructions for different camera setups.
Some with more than one and motion sensors.
Sorry I don't have much more but I have only
a few cameras in the boxes.