X10 Community Forum
📸Cameras & Camera Software => Camera General Discussion => Topic started by: hank on November 23, 2005, 05:28:37 PM
-
Okay, I think I've got everything installed
correctly. Xray vision is up and running
(but I have no picture). I have the X10
Capture Device listed under the Imaging
Devices hardware listing.
I have the VR31 powered on and the yellow
video cable going from the VA11A to the VR31
(is this correct)?
But still no picture!?
Is there a comprehensive online manual that
describes how to configure everything?
Help!
Thanks!
-
Have you looked in the X10 Support Area. I
know that there are some Inatalation
Instructions pages there. Some are detailed.