X10 Community Forum

🛡Home Security => Home Security General => Topic started by: rtree on June 30, 2004, 11:33:58 AM

Title: Motion Detector setting off console at entry
Post by: rtree on June 30, 2004, 11:33:58 AM
Hi,
I was just testing out the security system,
and i set everything on a delay so that i
can get out of the house for a minute, and
so i can enter the house i believe it's 30
seconds, but i have to pass threw a motion
detector to get to anything, isn't there
supposed to be a delay on motion detectors
when you first enter the house? Any help
would be appreciated.
Title: Re: Motion Detector setting off console at entry
Post by: kishore on July 04, 2004, 12:02:34 PM
On the motion detector set the slide switch
to position 2 to trigger only after two
movements have been sensed. This might give
you enough time to enter and disarm the
system