X10 Community Forum
🛡Home Security => Home Security General => Topic started by: chad v on December 31, 2004, 12:25:13 PM
-
I had an issue with a cordless phone being
to close to the console so I unplugged the
console and took out the battery. I then
removed all the batteries from the sensors
and pressed the test button for 3 seconds.
I went through the house and placed the
batteries back in and moved the console
back to install from run 1 and pressed the
test button once got the two blinks and
pressed it again and I continue to get a
series of fast flashes as if it was never
cleared and it wont reregister with the
system. I have tried every sensor and
remote and cant get anyting to work again.
It previously worked perfectly before the
issue with the cordless phone. I have
since moved the phone back to where it cas
previously alright. Any ideas?
-
Have you removed the Battery and the AC
Power from the Security console, then wait
aprox 3 minutesbefore re conecting the
battery and ACpower to the console, then
try to log in again all Sensors moving the
switch to the "install" postion
-
The problem is that the sensor was already registered. That is why the flashing light.
I know that it doesn't seem to make sense BUT that's what it is.
Here is what I would suggest.
Unplug and remove the battery from the console.
Put the console in install mode.
Wait at LEAST 5 minutes.
Re-install the battery and plug the console in.
NOW begin registering your sensors.
Hop this helps.