X10 Community Forum

🛡Home Security => Home Security General => Topic started by: jeff on March 29, 2005, 08:37:49 PM

Title: Best batteries for X-10 sensors
Post by: jeff on March 29, 2005, 08:37:49 PM
Does anybody know
Title: Re: Best batteries for X-10 sensors
Post by: loveschools on March 30, 2005, 03:07:55 AM
Well, I don't know if they are the best,
but they sure seem better, and less
expensive, in the long run, than any non-
rechargable batteries, I have ever used.

In other words, I have been very pleased
with the NiMH rechargable batteres.  They
seem to last longer on one charge than a
non-rechargable Alkaline Battery.

Several years ago, I was displeased with
NiCD rechargeable batteries, but it seems
they now have it right, with at least NiMH
2000mAh rechargeable batteries.

Some NiMH batteries can recharge in 15
minutes.  I started out using them for
Digital cameras, now I use them for almost
everything.  They last until I lose them so
far.

I hope this helps, and if someone else
knows better battery solutions they will
repsond.

Good question.

Tim  
Title: Re: Best batteries for X-10 sensors
Post by: Brian H on March 30, 2005, 04:15:08 PM
For real cold. Though expensive Lithiums
will go colder than others.
Title: Re: Best batteries for X-10 sensors
Post by: tony on March 30, 2005, 06:07:08 PM
regular batteries typically work mine have
lasted 2 years. I would check distance
between base and sensor, could be too far or
thre is interference.
Title: Re: Best batteries for X-10 sensors
Post by: thedanc on March 30, 2005, 07:02:48 PM
I found that NiMH batteries tend to sit at
about 1.3V whereas a nice, new alkaline sits
at 1.6V.  The strength of the transmitted
signal seems proportional to the available
voltage.  My transceiver cannot hear a 2.6V
(two cells) powered motion sensor, but can
hear it when it has 3.2V.
Title: Re: Best batteries for X-10 sensors
Post by: andrew on August 21, 2005, 06:59:36 PM
I got a 36 pack AA energizers at home dept
for $12....
Title: Re: Best batteries for X-10 sensors
Post by: thedanc on August 23, 2005, 01:23:23 PM
Yepper!  No need to get fancy with the NiMH
or NiCd. The simple throwaway alkalines have
a higher standing voltage, lower cost, and
better yet a longer shelf life.  I find that
the rechargeable cells tend to self-
discharge much faster than the low current
draw of the sensor I installed them in.  The
rechargeable cell is completely dead within
a few weeks even sitting on a shelf (but
rechargeable) whereas the throwaway alkaline
is good for 6 months so far.  "Tony" can get
2 years out of them.
Title: Re: Best batteries for X-10 sensors
Post by: kathy on September 24, 2005, 09:17:11 PM
Hey, has anyone thought about solor battery
chargers? Boy, this would be great for a
power source. Please respond if you have
heard of them being used with this
application.