X10 Community Forum
🛡Home Security => Home Security General => Topic started by: ken riddle on December 03, 2005, 02:39:53 PM
-
I have a MS10A Motion Sensor and it is
installed on 2 zones (#4 & #5). How do I
clear one of them from the Base Console?
Any help will be appreciated! Thanks,
Ken
-
Only way I have seen is unplug the console
and remove the battery. Wait for the thing
to loose all its data. Then start from
scratch.
-
Brad,
I determined the same. Looks like the
would have some method to clear a zone to
re-program it, but there's not.
Thanks for your answer.
Ken Riddle