X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: jim on December 04, 2005, 09:54:56 AM
-
I have an all lights out function my
security system tht uses X-10 commands to
my outside lights. The secuiry systemn is
not X-10 buts sends A code when I use theat
function. It does not even show A1, just A
in the AHP log of events. The problems is
that it turns off other units using othe
housecodes. How can I prevent this? I have
tried removing the other codes from the
transceived list with no success.
-
Other House Codes? I have seen all units off
and all lights off X10 commands but they are
house code specfic.
-
I found that my alrm system sends all
lights out to all A & B house codes. I
changed my house codes and eliminated the
problem. Weird setup fpr sure.
-
OH that can do it.