X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: jt on December 04, 2005, 07:05:06 PM
-
I have a wall module that has been in for a
couple of year. Now the "on" command works
fine from the remote or the switch but
the "off" command dims the lights to about
50% instead of turning them off. Has
anyone else had this problem? I end up
using the little switch below the button to
turn of the lights but that disable the
remote. Is this switch dead?
-
Assuming you tried to send OFF again to this
module with no change, was something added
(plugged in anywhere) that could be causing
some weird interference ? Normally
interferance causes loss of signal but I
guess it could cause modification to the signal.
No software on your computer sending virtual
command either?
-
I don't have X10 hooked up to the PC yet so
no weird signals from there. I haven't
added anything new to the house. I'm going
to try and switch the channel and see if
that solves the problem.