X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: bowlofpudding on January 25, 2006, 03:07:32 PM
-
ok, heres the issue, my transceiver was
working fine for the longest time, but for
no apparent reason its not respond to any
rf signals from any of my remotes. im also
using a radioshack "plug 'n power" wired 8
device remote control. could that have
interfered with the transciever to make it
not work at all anymore?
-
Try unpluging the RS as a test, but I doubt
it. If you are next to the tranceiver with a
remote. Does it still refuse to turn on and
off with the house code unit #1 command; or
is the problem the remote can turn it on and
off; but it doesn't seem to send line
signals to other modules in the home? If it
doesn't control other modules but the remote
will toggle the tranceivers relay. It could
be a line signal problem. Anything new in
the home around the same time the tranceiver
started looking bad? Like a new computer tv
etc.?