X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Wish List => Topic started by: james on April 30, 2005, 04:37:59 PM

Title: AHP Security Macro
Post by: james on April 30, 2005, 04:37:59 PM

X10, it would be great if the Active Home
Pro had the capabilities to recognize an all
on-off command from the DS7000 and start a
macro when the DS7000 went into alarm mode.

Title: Re: AHP Security Macro
Post by: aaron on May 04, 2005, 05:28:55 PM

I've tried to start a macro on the CM15A
from a module that was being turned on and
off by the DS7000. Apparently the flash rate
was to fast for the CM15A to respond to. So
the modification should make sure it could
respond to the on-off rate of cycling of the
DS7000.