X10 Community Forum
X10 Zone => Contractor General Discussion => Topic started by: john whinery jr on November 10, 2005, 06:34:55 PM
-
I am having a problem with my first setup.
First I installed the PLW01 wall switch then
added the batteries and plugged in and
installed the CM15A and the AH Pro Software.
So far so good.
#1 - Now I set up my switch in AH Pro and I
can turn the light on but not off from
within the software.
#2 - With the module set to be on from dusk
to dawn the light will shut off after about
60-90 minutes?
Any help would be appreciated.
-
Please email me at kellyp@x10.com for a very
informative reply that is too long for this
forum.