X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: Akasonny on February 24, 2006, 01:36:06 PM
-
When I pull up the Timer Designer (version 3.201 AHP) there is an ON-TIME function but the OFF-TIME function isn't displayed. I searched forum for this problem to no avail. Anyone else have this problem? I can't configure the timers without an OFF-TIME function!
-
It sounds like you're opening the Timer Designer for a macro. Macros only have an on time which is used to tell the macro to start running. The events of the macro determine when it stops. If you open the Timer Designer from a lamp or appliance module, you should have both on and off times available.
-
Good call! ;D Yes that was my problem. Kinda confusing...as I wanted a macro to start at dusk and end at a pre-determined time...