X10 Community Forum

🔌General Home Automation => Automating Your House => Topic started by: smcwhorter on February 25, 2006, 02:25:57 PM

Title: ws467
Post by: smcwhorter on February 25, 2006, 02:25:57 PM

Just a quick question. I have installed the ws467 and it turns the lights on and off manually, but the controllers have no effect. The transceiver is set and I set the address on the wall switch, but nothing happens remotely. What gives? :o

Title: Re: ws467
Post by: poursha on February 25, 2006, 02:30:50 PM

Try the standard fixes!:

1.  You may need a phase coupler.

2.  You may need a filter on a noise source (like a TV of computer nearby).  I had this problem with one of my switches.  It worked manual, but it would not take line signals very well.  I unplugged the TV in the next room, and it worked fine.  I installed a filter later, and that works great.

Rob

Title: Re: ws467
Post by: smcwhorter on February 25, 2006, 02:44:51 PM

Thanks, this makes sense. I' ll get right on it.

Title: Re: ws467
Post by: Tuicemen on February 25, 2006, 07:33:21 PM

You don't say what your using for a transciever many of us asume it is the cm15a but that may not be the case. (as you say the transciever is set)this makes me think your using a tm751 or something simalar. If thats the case then it could be other things be a little more discriptive with your post eg what house codes your using  and type of transciever.