X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Multview and Webview => Topic started by: chinaboy on March 28, 2006, 04:19:41 PM
-
Can anyone help me correct this problem. I have my Inside Cam set to A1, Backyard to A2, Front door to A3 and Flood Cam to A4. When I label them in multiview the pictures show up in the wrong window. Is there a way to make cameras show in the correct window. I am having trouble setting up the trigger on motion feature in multiview because the cameras are not in sync with the software. Any incite on this problem will be greatly appreciated. I have contacted X10 support, but they forward me to someone else and haven't heard back from them. Is this a problem with the software or is my laptop just not good enough for it. I tried removing the software, but when I re-install the label were still saved. How can I remove the software without leaving any traces that I had it on my computer at all? Multiview always reinstall with the same information from my previous settings even after I remove it.
-
Did you ever get a resolution to this? I am having the same problem.
-
I am having the same problem.
I don't think the problem is your laptop. I have made the same type of set up on my server and have the same problem.
- pictures show up in the wrong window
- removing the software, but when I re-install the label were still saved.
- trouble setting up the trigger on motion feature.
I have been troubleshooting the third one and it appears to be the reception on the CM19A.
I am seriously considering returning the stuff. I hope we hear something soon on a resolution to these issues.
Tks
Kevlar
-
I have contacted the tec support and they say this is normal.
They say we should change the name we put in the window tab. I explained that the images change in the windows and also that when you click on the live feed it would then be a different image that what the name says.
This is nuts.
I am considering returning the complete system. There seems to be a real lack of support for the product.
-
I too am having the same problem .... seems a shame to have spent this much money and not have the ability to do what I want >:(
-
After hours of searching, reading and online with live support, I've discovered that the MultiView software won't work without the Firecracker module, CM17A ..... hope this helps
-
I was using the CM19A wireless PC Transceiver.
-
I had to plug in the CM19A Wireless PC Transceiver and the TM751 Small Wireless Transceiver before it understood all the camera and showed them seperately in each picture.