X10 Community Forum
🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: croc4 on June 17, 2006, 09:10:06 PM
-
I recently purchased some X10 stuff, and the inital purchase worked fine WS13A-c, lamp module and power house remote.
I then purchased some additional modules since the first set work so well, the second purchase was another WS13A-C and the WS14A-C and companion (I think that is the modules). Anyway, I connected the second WS13A-C in the hallway and the WS14A-C and companion as a three way dimmer in the kitchen. from the switches themselves they work fine, but now here is the problem. The second WS14A-C can only be turned on remotely, cannot be turned off unless you go to the switch. The dimmer/three way can only be turned off remotely, it will not turn on unless you physically go to the switch. The other odd thing is that if I turn on the second WS13A-C the original WS13A-C that worked fine before will no longer respond, I have to make sure the second WS13A-C is off and the original WS13A-C works fine.
I have wired up both the same way, and providing the wiring is the same (white is white and black is black etc) there should be no problem. Any ideas?. I disconnected the three way switch thinking that maybe that was causing a problem but still does not work.
I need help from the guru's