X10 Community Forum
🎭Entertainment => Entertainment General => Topic started by: jimmy4040 on July 19, 2006, 02:04:39 PM
-
I just purchased this product Wireless Video Sender. I am experiencing problems getting my cable box to work with this device.
The cable box has a coax and RCA outputs. I know both of them are live because I tested it on TV together.
As soon as I plug the sender in the RCA outputs the cable box shuts off. It doesn't come on back until I unplug it.
Any ideas?
My plasma is in the master bedroom and it is locate in a weird place. Please help provide a solution.
-
Do you know if the RCA Jacks are Composite Video and Analog Sound?
-
thx for replying brian.
I finally got the video to display on the secondary TV.
Here is the new problem. As soon as I pugged the IR cable in box I get "unusable signal."
Any suggestions will help.
PRIMARY TV
========
BTW, in order to get my setup to work I had to disconnect all the cable.
I then use the RCA cables on the sender and plugged it into the RCA audio and video on the cable box ( I left the TV disconnected).
I then plugged the receiver in and plugged into video 3 on my seconday TV. Once the seconday TV start working I used the coax for my primary TV.
----------------------------
Now my problem is changing channels. Please help X10 guy. My roommate is laughing at me. She said it would have been cheaper to get a second cable box. I want to get the TV on the deck working. So, she can buy me a couple of drinks free. :)
help techstaz!!!
-
Can someone offer some assistance with the IR connect problem?[
-
I'm having some trouble with the Video Sender too. I can get everything to work on my secondary TV using the RCA Out on the cable box, but the only way I can see anything on my primary TV is by unplugging the RCA cables from the back of the cable box.
Do I need a switch box now? ???
-
I figured it out!!
Everything works! I just had the TV/VCR button pushed for my TV, so the cable wasn't showing. It's working now!