X10 Community Forum
🛡Home Security => Problems and Troubleshooting => Topic started by: ahubbar on August 02, 2006, 01:20:54 PM
-
I get a slow flashing LED Zone 1 after 4 hours. I do not have a sensor assigned to Zone 1. During the Install process, the security remote or 'something" latches itself onto Zone 1. Have unplugged battery, and AC plug and followed the instructions many times. Problem is repeatable, other sensors all work fine. Any advice on isolating this?
-
Never mind, I figured it out. Remove batteries from motion detector. Then reinstalled all door sensors, then reinstalled motion sensor batteries, then push code and test on motion sensor. Then reinstalled all remotes. The motion sensor was occuping two zones, zone one was a phatom zone for the motion sensor. The motion sensor couldn't report in to two zones, thus the blinking LED after four hours. The installation instructions aren't all that clear. Must have been written in chinese then translated. On another subject, does anyone know why pressing 0 to listen in doesn't work when the security console dials a cell phone?