X10 Community Forum
🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: robandcathy on August 15, 2006, 08:58:44 PM
-
I have the macro function, with the eagle eye sensor on D1 I set that to my trigger and the first line is to turn on B2 Front door light wait 5min and then off, I look in my activity monitor and see that D1 is received but I never see the B2 ON signal sent, does anyone why? from my remote B2 works fine also the sensor has fresh batt. so I'm sure the signal is good
-
Try a one second delay in the macro before B1 activation. This worrked for me in a similar situation
-
I meant before the B2 ON activation
-
Do you see a 'B2 ON' being sent if you manually activate the B2 module from the AHP GUI?
-
Make sure House Code "D" is set as a "Tranceived House Code" in AHP Hardware Setup.
-
will the house code tras.. set to d affect the timers on the a code ; this is my setup A and B are all my switches c is cameras and D is sensors what would be the best way to set up my usb transciver, i have timers to trigger lights for me in the morining on the a code
-
will the house code tras.. set to d affect the timers on the a code ; this is my setup A and B are all my switches c is cameras and D is sensors what would be the best way to set up my usb transciver, i have timers to trigger lights for me in the morining on the a code
From my experience with AHP, I would suggest setting all of the houscodes to transceived unless this causes problems. I think the macros will not be triggered if the house code of their trigger isn't set to be transceived.