Using flags in Conditions?

Started by Walt2, December 16, 2006, 10:12:58 AM

Previous topic - Next topic

Walt2

I can see how to set and reset flags, but I also want to use them.

In the Condition Wizard in the Macro Designer, I can't seem to find a way to select them, flags, as a condition.  I mean, want to build/design a macro that will run if a certain flag is set, and not run if the flag is reset.

There must be a way to use them, otherwise, why have them?
* Sears Home Control System, Radio Shack Plug 'n Power, NuTone, Stanley LightMaker, BSR, HomeLink.
* Tecmar Device Master, CP290 (LightHouse), CM11A (AH), CM14A (AH2), CM15A (AHPro).

Puck

Go to Tools / Preferences and select the Smart Macros tab.

UNCHECK Show Smart Macro Wizard for New Macros

SELECT Smart Macros Interface: Advanced

Now when you create a new macro, select Use Conditions and you will now see the Flag Status condition (on the left) that you can drag & drop into your condition. From there you can select which flag(s) to check for and to check if they are SET or CLEARED.

Walt2

* Sears Home Control System, Radio Shack Plug 'n Power, NuTone, Stanley LightMaker, BSR, HomeLink.
* Tecmar Device Master, CP290 (LightHouse), CM11A (AH), CM14A (AH2), CM15A (AHPro).

TakeTheActive

Quote from: Walt2 on December 16, 2006, 10:31:23 AM
Wow!  That's it!  Thanks!!!!

Gentle Reminder: Don't forget to CLICK on "Helpful on the far left side of Puck's
"EXCELLENT :) / THOROUGH ;D / LESS THAN 12 MINUTES AFTER YOU POSTED :o"
reply. ;)

Keep in mind, we are all VOLUNTEERS here, and your thanks and appreciation is our *ONLY* reward!
8)
Low Post Count != Low Knowledge - High Post Count != High Knowledge ;)

ADVICE TO X-10 NEWBIES FROM AN X-10 OLD-TIMER

SMF spam blocked by CleanTalk