Ok so i've been playing with the x10 hardware for just over a week. Been working great i installed activehome pro on my laptop and works great around the house with the remotes. ive also been programing the voice activation at work during my spare time and bvc is working out great. also i run my stuff at home via aluminum wiring and works just fine. Anyways today i brought my pc from work home to test the voice activation and for some reason when i plugged in the usb all my inputs went dead. i couldnt trigger my lights with my remote like i usually could. I dont know why this happened cause i was using the remote just before i plugged in the usb and it was working fine... i deleted all the modules from ahp and started fress and could turn on the lights via ahp just fine, but nothing from the remotes... so after reading on here i thought that my rf antenna went dead... not like i got new electrical noise in my house since nothing changed and it worked all week. I unplugged everything waited 15 minutes plugged it back in put the batteries back in but my remotes would not work... i ran the F2 diag on ahp and these are commands i saw.
D4 ON
D4 ON
D4 ON
when i pushed my remote button for my d4 light figure.
and see
D4 OFF
D4 OFF
D4 OFF
when i hit off....
however when i trigger it in ahp i see
D4 (New LM15A)
D On (New LM15A)
D4 (New LM15A)
D Off (New LM15A)
....
so whats going on do i have a faulty board?
well i kept on investigating and remebered i had ahp loaded on my laptop so i connected the usb to it and viola i get the same commands as ahp sends via the remote...
so can anyone explain why the commands are different on my main pc ?
Author
Topic: Maybe your CM15A is not bad after all... READ (Read 2289 times)