Hi I have a rather extensive x10 setup on a rather large 200 amp distribution system
Own two Cm115a usb controllers which I will connect to top of panels each on either side if the incoming Phase
I.e. controler cm115a(#1) on phase(a) and controler cm115a(#2) on phase(b)
My question is about the cm115a internal usb connectors, I would like to run both to a single usb hub and then back to the
controlling computer but worry about internal phase crossing on usb bus.
also can anyone tell me if the x10 home control software will be able to deal with seeing twin controllers in the same program?
can it detect and discern the individual controllers?
I have no problem with both acting as Clone interfaces as long as they both respond and store downloads etc.
or Will i have to have two instances of the software running?
I am looking at this set up as i Do a lot of video and audio work have out buildings, and aux devices far and wide and
experience occasional interference porblems.
Thanks for any feed back and experiences!
Michael Brzezinski