Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[harley_52]

Whenever I arm my X10 security system (PS 561 console) I get a repetitive alarm that will not stop until I disarm the system.  I have no lights lit or flashing so all my sensors appear to be working correctly.  I've even switched consoles, and both do the same thing.

Any ideas?

[dave w]

From the DS7000 manual:

Trouble Alarm
If you hear a repetitive trouble alarm when you try to arm the system there is a problem
and the system does not arm. You can:
• Correct the Problem - First press DISARM to stop the trouble alarm. Then correct
the problem. Then arm the system again.
• Ignore the problem - While the trouble alarm is sounding, press BYPASS. The
indicator(s) for the problem zone(s) flash rapidly. Press ARM to arm the system. The
problem zone(s) is/are not protected but all other zones are.

[Puck]

I have no lights lit or flashing so all my sensors appear to be working correctly.

I just want to add the following note: If you have more than 8 zones (sensors) you need to press & hold the "Bypass" button to see the status of zones 9 thru 16.

[harley_52]

***From the DS7000 manual:

Trouble Alarm
If you hear a repetitive trouble alarm when you try to arm the system there is a problem
and the system does not arm. You can:
• Correct the Problem - First press DISARM to stop the trouble alarm. Then correct
the problem. Then arm the system again.
• Ignore the problem - While the trouble alarm is sounding, press BYPASS. The
indicator(s) for the problem zone(s) flash rapidly. Press ARM to arm the system. The
problem zone(s) is/are not protected but all other zones are.***

Thanks, but I saw all that in the instruction manual and tried it.  Still no go.

As it turns out, apparently the sensitivity switch on the remote control unit was set to "max" and that's what caused the constant, repetitive alarms without any lights lighting.  I set it to "min" and the symptoms cleared.

[Puck]

As it turns out, apparently the sensitivity switch on the remote control unit was set to "max" and that's what caused the constant, repetitive alarms without any lights lighting.  I set it to "min" and the symptoms cleared.

OK. When set to "Max", that is a one minute delay for you to exit the house before it arms.