Commands loop continuously since adding transceiver to CM15a equipped system

[dash]

Many thanks Boiler

I'll remove Housecode H from list of transceived codes as suggested.

  DAve

[dash]

I've found I've had to add the 2 second delay at the beginning of ALL my macros to stop the looping (thought it might only have been required for those macros which sent a command to H1 - the address of the transceiver module).

I thought I'd seen somewhere else in the forums that adding a time delay at the start of a macro would cause issues. Can anyone remind me of what those issues might have been?

Thanks

Dave

[Puck]

I thought I'd seen somewhere else in the forums that adding a time delay at the start of a macro would cause issues. Can anyone remind me of what those issues might have been?

This issue was seen with a macro that is part of an ELSE string of macros. When it started with a delay, it tends to execute regardless of the execution conditions. This problem was not seen in a single stand-alone macro that starts with a delay.