Contact | X10.com
Please login or register.

Login with username, password and session length
Pages: 1 [2]

Author Topic: Promblems with Vanguard setup  (Read 21256 times)

suesloan

  • Full Member
  • ***
  • Helpful Post Rating: 1
  • Posts: 67
Re: Promblems with Vanguard setup
« Reply #15 on: June 09, 2009, 08:46:33 AM »
Make sure you used the Ninja  power supply and not the camera power supply. They are different!

Also, I found a bad electrical circuit in my house was killing all my cameras yesterday. A light in one room was flickering. I found its circuit breaker and turned it off. Cameras all back to OK now.

Sue
Logged

kphigh

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 12
Re: Promblems with Vanguard setup
« Reply #16 on: June 09, 2009, 09:02:02 AM »
Hi Sue,

There was only 1 power supply with my Ninja.. the camera plugs into the tilt and pan base so I think I'm ok there..   I used to have the Home Automation on my lights until I switched over to CF lights so I think the wiring should be ok, but I'll try a couple of different outlets and see if that helps...

thanks for your help..

kevin

Logged

kphigh

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 12
Re: Promblems with Vanguard setup
« Reply #17 on: June 10, 2009, 08:57:01 PM »
I tried Sue's suggestion and I also re-install the software and still nothing.   Any other ideas?  Maybe I should just send the whole system back...   :(
Logged

kphigh

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 12
Re: Promblems with Vanguard setup
« Reply #18 on: June 14, 2009, 02:01:52 PM »
Tried one more time.  removed and installed all software, disconnected the wireless router and 5.4ghz phone and still no go.. quess I'll be returning everything tomorrow   :(
Logged
Pages: 1 [2]
« previous next »
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.