VT38a and VA11a infinite recording loop

[20110907]

Hi.

I got a VT38a (flood camera) by itself, and it worked fine.
When it detected motion, the video receiver would pick up the feed it was sending.
Then after a while, the floodcam's camera would turn off and I would lose the feed. I was happy.

Now I have the iWatchOut on AHP, and having problems.
I set up two macros and a module:

Module 1: VT38a on E1

Macro 1: Start Recording
  On trigger E1 ON
  Video Recording Start

Macro 2: Stop Recording
  On trigger E1 OFF
  Video Recording Stop

When something triggers the E1 camera, it starts recording.
However, after the time delay (Set in the VT38a), it seems to start right back up again.
I get about 30 individual 3-minute recordings before the AHP crashes.
If it happened at night, the floodlights are always on, and I have to use the circuit breaker to get them to turn off.

I've read other topics, and do not feel it's the floodlights, the wireless router, etc.
When I remove the software component from the equation, it seems to work fine again.

[20110907]

I find even without the recording software,
the floodlights will not turn off once motion is detected at night.

I transfer this post to a new post here, and defer advice there before coming back to this.
http://forums.x10.com/index.php?topic=25263.0