Topic: New to X10 Trying to control map module using usb Firecracker (Read 2820 times)

ijourneaux · « **on:** July 08, 2010, 08:58:14 PM »

I have an LM465 lamp module I want to control using a USB firecracker and the firecracker software.

Everything seems to be installed correctly but I can't get the lamp module to power on and off. The lamp module is at the default value of A1 when I use the firecracker software to try and send off to A1, nothing happens.

Probably something stupid but can't seem to get past this.

-Bill- (of wgjohns.com) · « **Reply #1 on:** July 08, 2010, 09:30:18 PM »

Welcome ijourneaux!

You're missing a piece of the puzzle.

The Firecracker only sends radio signals and the lamp module only hears power line signals.

You need a translator a.k.a. "tranceiver" like the TM751 to put the RF signal onto the power line.

ijourneaux · « **Reply #2 on:** July 08, 2010, 09:58:03 PM »

As I was digging into it that is what I came to conclude. Thanks for the info.

News:

Author Topic: New to X10 Trying to control map module using usb Firecracker (Read 2820 times)

ijourneaux

New to X10 Trying to control map module using usb Firecracker

-Bill- (of wgjohns.com)

Re: New to X10 Trying to control map module using usb Firecracker

ijourneaux

Re: New to X10 Trying to control map module using usb Firecracker