Every Command is send 3 times

[needacloud]

Hello,

i am new to this forum! I am going mad with that X10 Stuff. I have setup a new Windows 7 Home Client with an CM15PRO plugged into it. I installed the drivers and the ahsdk. Everything works so far, the only problem that i have is that every command is send three times. It doesn't matter if it is a Command for an SW12 or for any other device.

Before the new PC i had a test installation on a Vista Notebook and there it worked normal. It would be great if you could give me hint how to go on, because i reinstalled my PC a several times now and the problem remains.

Thank you!

Miran

[Noam]

In your timers, see if you checked the boxed marked "repeat." That causes AHP to resend the command for that timer three times, to give it a better chance of overcoming noise.

[Brian H]

Drivers and ahsdk installed.
Are you using AHP or some custom software you are developing?

[needacloud]

Hi,

thank you for your replies.

I have no timers so far.

i have only downloaded and installed ahsdk_install Package. For Testing Purposes i send the commands from a DOS Prompt, for Example ahcmd.exe sendplc B10 Bright 2, i can see it in ahcview that the command appears 3 times and the modules are also reacting 3 times.

But nevertheless i had also AHP installed and tried to send some commands, and they were also send 3 times.

Regards

Miran