I thought I would give you guys an update on this. It is working. The PAO11 was a poor choice because it's not what I thought it would. I thought each socket would get its own circuit like a regular wall outlet. Instead, this device is nothing but a 2 socket power strip with a built-in PAM02. So, I went with 2 PAM02's being controlled by the PSC01. I attached a low power power supply to the PSC01. The power supply is controlled by the switched outlet on the back of the receiver.
It's almost perfect. Where it's not perfect is in its timing during power up. The outlets trigger immediately when the receiver is powered on and delayed when the receiver is powering off. Technically, the power up should be delayed and the power off should be immediate due to possible signal spikes during receiver power on and off. The receiver or the sub seem to handle it well. I have not noticed any spiking. So, this will work just fine.