Motion Sensor/Wall Switch Problem

[chad]

I set up a motion sensor to activate
overhead lighting via a wall dimmer switch
(WS467).  The switch is turning on when
motion is detected but it is setting the
output to 0% so I get no light.  How can I
get it to set it to 100% or preferrably
even a lower setting when it detects motion?

[Brian H]

What is the motion sensor triggering? A
macro in the AHP interface [cm15a] or
directly on the wall switches address
through a tranceiver [cm15a's receiver or
maybe a TM751]? Remenber by default a motion
sensor after one minute of no motion. Sends
a off command.

[chad]

I saw your post in the other forum.  I
checked the hardware settings and found
that it must default to none for tranceived
codes.  I changed it to auto and it seems
to be working fine.  Thanks for the help!