3.178 Flags Clear not working using Macro and Remote

[h j flynn]

XP sp2, AHP 3.179

I create 2 Macros F1 (on) F1 (off) which I
was using to clear or set the flags 1-5.
They were working in 3.175.

With 3.177 and 3.168 If I run the Macro
using my PC they work fine. However if use
a remote HC40TX or HR12A the set flag 1-5
works MACRO F1 (on) but if I try to clear
flags 1-5 MACRO F1 (off) they get set
instead of cleared. Also MARO does flash
when RF is sent and the log also shows the
the correct macro running.

What I am using this for is, I have a 2
MACRO D1 & D2 that is run by a motion
sensors.  I check the Flag (1), if clear it
sets the Flag (1), chimes on, robo dog on,
waits 1 minute, clear Flag (1). I do the
same thing with another MACRO D2 and motion
sense  using Flag 2, but chimes twice.
(door bell 2 for front, 1 for Back). These
Macros are setting and clearing the flag
(1) correctly. The reason I created a MACRO
to Set / Clear these FLAGS with a remote
was to be able to turn the chimes and robo
dog OFF when kids are play out on the back
deck or we are having a lot of company. Any
Ideas on what could be causing the MACRO
when using a remote to clear flags to set
them instead.

[X10 Pro]

If you send the .AHX file for this to
ahpsupport@x10.com I'll take a look. It could
be that the Clear/Set command isn't being
processed or set correctly.

[h j flynn]

X10 Support, .AHX file e-mailed

[h j flynn]

X10 support (Michael), thanks for your
quick e-mail response explaining problem, I
will check for the fix in next release,
until then I will us my PC to set the FLAGS.

[h j flynn]

X10 Support, 3.179 fixed this softeare
problem.

Thanks for addressing this so quickly,
great job.