Dear Sirs,
I have a problem with the new AHPro software
ver. 3.198. When you turn off transceived
house codes, the software still see RF
signals. The animated Icons respond but don’t
send the signal over the power line, except
for macros. The macro responds, which then
turns on everything in it. Also the receiver
in the CM15A is not near as good as the
receiver in the TM751. I have tried to turn
off the receiver in the CM15A and use my
TM751which is in a better location to receive
from all over my house, but with both
receivers working they lock up.
