Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[clinton]

I have purchased four X10 motion lights
thinking I could set them up so that if any
one of them was triggered, it would turn on
all four.  But because of the +1, +2, etc.
way of sending codes, this doesn't work.
Does anyone know how I can make this work,
or what should I have bought to do this?
Thanks.

[joel]

Seperate EagleEye Motion detectors and wall
swtiches or socket rockets. Set them up. Each
sensor will trigger all of the lights, just
set them to the same code.

[bo]

You will have to purchase the Active Home
software.  I have six motion detectors that I
want to respond the same way as you do.  I
have desiginated (3) motions as P1, sending
codes P2, P3, and P4.  The other three
motions are O1 that sends codes O2, O3, and
O4.  I have made six macros named P2, P3, P4,
O2, O3, and O4.  The motions transmit trigger
codes that call these macro.  Each macro then
turns all lights on.  I have also placed a
delay and an all lights off command after 2
minutes. I am still in the trial stage and it
seems a little "flaky" but hopefully it will
settle down.  Tech support helped me with
develop these macros.