Please login or register.

Login with username, password and session length

Author Topic: motion sensor Ms-16A  (Read 5906 times)

daystar

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 5
motion sensor Ms-16A
« on: December 18, 2005, 01:41:48 PM »

My setup consist of the Ninja Pan'n Tilt
Model Vk74A, TransiverModule TM751, Active
eye indoor/outdor sensor Ms 16A and Audo
Receiver VR31A.  Everything works Great
excep for the Sensor MS16A that should be
turning the camera on and it's not.  I am
confused.  Help!!!!!!!!!!
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: motion sensor Ms-16A
« Reply #1 on: December 18, 2005, 04:25:57 PM »

Is the sensor sending an ON signal on the
address the cmaeras supply is set to. If you
have another module like a lamp or
appliance. Try setting it to the address of
the cameras supply and plug it into the same
outlet as the supply. That will see if the
line signals are actually reaching the
cameras outlet. The pan and tilt controls
doesn't go thorugh the house wiring but
directly by an RF signal from the remote to
the mount. Also can you use a remote through
the tranceiver to control the camera?
Logged

daystar

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 5
Re: motion sensor Ms-16A
« Reply #2 on: December 18, 2005, 05:21:52 PM »

I plug a night light into the transciever
and it is turning it on and off so i know it
is working.  I have the camera wall outlet
or better know as the mx14A set to 1 and "A"
Also just for testing. I only have the
camera pluged in , the transciever pluged in
and the sensor has the two batteries in it
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.