Topic: multi cameras in AHP (Read 3553 times)

J Lawson · « **on:** March 21, 2006, 07:15:28 PM »

I have a 3 camera setup in AHP,when I switch cameras c1 c2 c3,most of the time c2 shows no video,the other 2 work fine.If I unplug the camera c2 and plug it in again it shows video fine,has anyone got a solution to this.
Thanks for any feedback.

X10 Pro · « **Reply #1 on:** March 21, 2006, 07:30:03 PM »

C2 probably isn't getting the command to turn on. Unplugging it and plugging it on makes it come on. Try moving the power supply to a different outlet. You could also swap places between C1 and C2 temporarily to see if it's the location or the camera itself.

J Lawson · « **Reply #2 on:** March 22, 2006, 07:41:02 PM »

I have one motion active eye and 3 camera setup in AHP,can you give me specific intructions to make my active eye work at my front door.I have a RF smart repeater and a transceiver and none seem to increase my RF range.I have tried both and I get no activity in the activity monitor,I also have a remote that I use at the front door and also get no response.X10 please solve this problem for me,or someone,anyone...
JL

Mystyx · « **Reply #3 on:** March 22, 2006, 09:41:02 PM »

First have a look at this thread about not seeing one camera out of 3.
Multiple camera reception help!

I had a similar problem with my front door all setup as RF atm. I use a repeater (NOT a TM751!!) on the same circuit as camera near the front. I have a thick cement wall outside surrounding my house.
you can try first place the sensor in a window (outside) and try.

News:

Author Topic: multi cameras in AHP (Read 3553 times)

J Lawson

multi cameras in AHP

X10 Pro

Re: multi cameras in AHP

J Lawson

Re: multi cameras in AHP

Mystyx

Re: multi cameras in AHP