Topic: Question on TM751 (Read 24772 times)

rimfire · « **on:** March 10, 2006, 02:36:47 PM »

I have a couple TM751 modules I think are bad and wish to test. I'm thinking the unit code on the outlet is fixed as "1." Is this correct?

Tuicemen · « **Reply #1 on:** March 10, 2006, 02:41:45 PM »

Yes TM751 address is always unit 1

You can't use 2 TM752s on the same housecode or you'll have problems

rimfire · « **Reply #2 on:** March 10, 2006, 02:55:16 PM »

Okay, I see the problem. The module works, but it doesn't respond to commands from the plug-in control. Is this normal? Either way, for what I have in mind, I can work with that.

The second unit is DOA. Not even the manual switch works.

X10 Pro · « **Reply #3 on:** March 10, 2006, 03:02:50 PM »

The TM751 only responds to RF commands for module control, not plug-in controllers (powerline).

Tuicemen · « **Reply #4 on:** March 10, 2006, 03:07:52 PM »

If TM751 is set to house code "D" then a command of "D1 ON" or "OFF" should turn ON/OFF anything pluged into that unit! manual switch should work as well! regardless of code settings.

as X10 Pro stated you must send the unit a RF signal!

James S. · « **Reply #5 on:** March 26, 2006, 12:35:44 PM »

If you need more than one transmitter, you may want to try using the RR501 as one of the transmitters.

News:

Author Topic: Question on TM751 (Read 24772 times)

rimfire

Question on TM751

Tuicemen

Re: Question on TM751

rimfire

Re: Question on TM751

X10 Pro

Re: Question on TM751

Tuicemen

Re: Question on TM751

James S.

Re: Question on TM751