VCR Commnder II with motion sensor

[INeedSomeHelp]

I'm trying to record from my camera via VCR commander. I'm facing few issues. Hope someone can help me.
I set my MS14A motion sensor to A1 and default off as 1 min and use TM751 house code A and lamp module A1. I programmed VCR commander as per instructions.

When the motion is detucted my Lamp module goes ON and REC mode goes ON in VCR. The problem is Lamp module goes OFF as expected after 1 min but VCR recording keeps going on without OFF. Any suggestions to STOP recording. When I programmed for STOP in VCR commander it recognized. I re-programmed 7 times but still it doesn't STOP. Not sure what is wrong in my side.

Thanks.

[billy]

VCR Commander will record for 5 minutes after the last motion is detected.
This is a fixed time so let your setup run and watch the red led. The LED should be blinking while
recording and then stop after the 5 min.