I'm getting there, with your help :)

[Jim 31452]

Again, thanks for all the past posts, very helpful.

My new question:
I'm using AH upstairs, a transceiver down stairs,  several lamp modules and some very basic timing on all the lamps... on at 6:00 PM and off at 11:00 PM - all is well.

Occasionally I have the need to turn on some of those lamps using remote HR12A, (regardless of the timer settings) and the lamps will turn on, which is great, but they will NOT turn off later that evening when the timer says they should turn off. Then, after running all night, they will eventually cycle back through the next day back into the correct on-off times programmed.

I'd like to think that by using a remote to turn on a few lamps a bit earlier than the set timer, they would STILL turn off at the timed setting. Or am I off base and once you turn on a lamp, it stays on?

Any help is greatly appreciated.

[Tuicemen]

Your timers/ macros shouldn't be effected by an early start. Unless modules aren't correctly specified in AHP or you have conditions in your macros which state if light off then run.
This would work how ever if you had two way modules or AHP was running when you turned on you light early.

[Jim 31452]

Well, as far as I know, everything is correctly specified in AHP... each room has lamp mods with correct settings, none of which are duplicated... I'm using A 1 through A 8 and I'm not using any macros.

[nklght]

What type of module are you using to control these lamps?  Which type of light bulbs are you using in your lamps.  I have a timer set up for my outside lights, I am using compact flourescent bulbs, and they always turn on, but they do not always shut off, because of the interferance caused by the bulbs themselves.  I can usually manually shut them off by using a remote and sending the single a couple of times.

[steven r]

..I am using compact flourescent bulbs, and they always turn on, but they do not always shut off, because of the interferance caused by the bulbs themselves....

As you've found out from your own personal experience, as well the experience of others here, CFLs can have problems working with the X10 signal. In addition to adding noise to the line, they don't allow a good signal flow through them. Some have had good luck using them in Socket Rockets. I also believe a neutral wire switch has better chance of working than the 2 wire ones. Do not try to dim them.

[Tuicemen]

Actually not all CFLs are noisy and cause problems.If one finds a noisy CFL try a different brand ! My home is 90% running CFLs and I have no problem with Noise from then Yet
I've heard they make dimable CFLs but I've yet to find any (my power company says CFLs are dimable, but they don't say which brand they based this on!)

[steven r]

...I've heard they make dimable CFLs but I've yet to find any...

I found this interesting site near the top of my Google search.

From the same site this one is a 15W bulb with a 60W equivalent output of light. I also liked that the description said it was "Electronic State of the Art Non Flickering Instant On". This might make it work better with X10.

[Tuicemen]

I've heard Phillips makes them too But I can't find them in my area Maybe I'm not looking hard enough! (I only dim 1 light in the house and a CFL won't fit in that fixture anyways)
Has anyone tried these dimables and do they work with X10 or just to noisy?