Topic: Integrating existing hardwired system with Protector Plus (Read 4600 times)

joe28 · « **on:** December 01, 2006, 12:24:57 AM »

Hello,
I'm new to the forum and would like to know if it is possible to integrate hardwired magnetic sensors from my existing system with the Protector Plus system.

Puck · « **Reply #1 on:** December 01, 2006, 01:38:26 AM »

The DS10A door/window sensors are also magnetic Normally Closed (N.C.) switches, so if your existing sensors are N.C. then you should be able to just remove the DS10A's sensor and replace it with yours.

joe28 · « **Reply #2 on:** December 01, 2006, 07:39:44 AM »

OK, but the Protector System appears to be totally wireless. How do I connect the wires from my existing switches, which are by the way NC.

Puck · « **Reply #3 on:** December 01, 2006, 09:08:44 AM »

Remove the sensor that is wired to the DS10A, then attach the 2 wires (from the DS10A) to the 2 wires from your existing switch. This will make your existing switch wireless for the DS7000 system.

Do this for each of your existing switches.

Tuicemen · « **Reply #4 on:** December 01, 2006, 10:08:24 AM »

You'll need the wire less window/door switches model DS10A

You can get 6 for $29 now!

scroll half way down the page!

Then conect your switches to these as Puck stated!

News:

Author Topic: Integrating existing hardwired system with Protector Plus (Read 4600 times)

joe28

Integrating existing hardwired system with Protector Plus

Puck

Re: Integrating existing hardwired system with Protector Plus

joe28

Re: Integrating existing hardwired system with Protector Plus

Puck

Re: Integrating existing hardwired system with Protector Plus

Tuicemen

Re: Integrating existing hardwired system with Protector Plus