X10 Switches not working through AHP after Power Outage

[sherrodclan]

My X10 switches are not working through AHP after I had a power outage.  Are the switches that sensitive?  Does anyone have an idea of what might have happened or what I should do?

[-Bill- (of wgjohns.com)]

My X10 switches are not working through AHP after I had a power outage.  Are the switches that sensitive?  Does anyone have an idea of what might have happened or what I should do?

My CM15A frequently refuses to function after a power outage until I clear it and re-download timers & macros.

[sherrodclan]

How do you clear the CM15A module?

[Dan Lawrence]

Open AHP.   You can clear the CM15A through it.   After you clear it, you can re-download all timers and macros.

[KDR]

You can also unplug the CM15A, Remove the batteries and wait about 10 to 15 minutes. Then hook it back up and upload your AHP settings to it.

^{----------------KDR}

[grumps96]

  I do not know if a power failures preceded my problem, but all my X10 units stopped  working. it was this way for over a week. I have a receiver set to the frequency of X10 and was receiving a strong unmodulated signal on it. I spent days trying to locate the source. eventually I unplugged the    AHP module and took out the Batteries, voila the signal stopped, and I was able to use my X10 controls again. I did have to reload my macros but that was to be expected.