Contact | X10.com
Please login or register.

Login with username, password and session length
Pages: 1 [2]

Author Topic: AHP "switches" wont work but Macro will  (Read 6703 times)

jsnone1

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 68
Re: AHP "switches" wont work but Macro will
« Reply #15 on: January 27, 2009, 10:05:36 AM »
ok, I unplugged all the Transceivers that I had in the house.......same thing....the Vanguard software can control the other modules, but AHP can not........... :( ???
Logged

jsnone1

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 68
Re: AHP "switches" wont work but Macro will
« Reply #16 on: January 27, 2009, 02:51:06 PM »
ok, the Vanguard software wont controll anything now...what was happening is that Vanguard was sending an RF signal and it was being picked up by my Alarm system!!!!

Tech support at X10 thinks I have a bad CM15A ( I bought a scratch and dent) so Im getting a new one.....we will see
Logged

alexo1us

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 37
Re: AHP "switches" wont work but Macro will
« Reply #17 on: January 28, 2009, 09:57:16 PM »
I think your load of the software got buggy if you can control it with sensors and remote switches it is not an RF or plc issue.
You may need to reinstall it but this first
clear the memory then reload try it.
Sometimes in windows the user profile gets buggy, the file we use is just a profile. Try opening a new file make aswitch to match, see if it works.
Alex
Logged
Pages: 1 [2]
« previous next »
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.