Please login or register.

Login with username, password and session length

Author Topic: Video Commander question  (Read 2035 times)

garagedude

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 20
Video Commander question
« on: April 30, 2009, 10:04:14 PM »

I have a UX23A video commander II which works fine if I use a remote to trigger the unit to record, but it will not start recording from anything else. Else being the PR511 or any macro. The CM15A is only 10 ft from the UX23A and the computer with the macro. The macro has an RF command it but doesn't work. It will turn on the cams, including the PR511 so I'm at a loss? what does the trigger do on the macros? I've tryed differant unit codes with no luck?
Logged

Tuicemen

  • Administrator
  • Hero Member
  • ****
  • Helpful Post Rating: 283
  • Posts: 10509
  • I don't work for X10, I use it successfuly!
Re: Video Commander question
« Reply #1 on: May 01, 2009, 07:33:51 AM »

The trigger in the macro is what AHP watches for and starts the macro when it receives that code.
 ;)
Logged
Please Read Topic:
General Forum Etiquette
Before you post!

garagedude

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 20
Re: Video Commander question
« Reply #2 on: May 01, 2009, 07:48:05 PM »

O,, Ok, that makes since. So if I got it figured out, the motion sensor will trigger the macro, which will trigger the cam which will start the sweep, but I haven't yet got the commandor II working with all this. Should the commandor be set to the same code that triggers the macro? I've tryed RF commands but the commandor ignores them??
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.